Clamping Point 22/50 30 mm

30 mm receded


Model MARO® clamping point 22/50 30 mm back.
Tensioning of the formwork according to a defined anchor grid. Production of sharp-edged, bleeding and discoloration-free tie points by means of a support cone with a closed-cell 10 mm thick sealing foam ring on the formwork side and a rear sealing foam ring between the expansion piece and the support cone.  Support cone height = 50 mm. The formwork tie has to be re-tensioned during the concreting process.

Sealing of the tensioning point with a concrete cone matching the concrete in terms of color and surface, approx. 30 mm behind. The sealing is carried out after sampling and after approval by the client.

The air-side clamping points are bonded with a one-component, grey adhesive. Bonding of the room-side clamping points (no damp rooms) with a single-component, non-flammable adhesive. Pre-cut fixed lengths are to be used as expansion tubes. Cutting of the expansion pipes by the customer must be avoided.

Product of planning: MARO® clamping point 22/50 30 mm


Walzwerkstrasse 30
47877 Willich


Unit: Piece          Price: