Clamping Point 22/50 5 mm

5mm receded

Produce anchor points with a shadow joint of approx. 5 mm receded

Model MARO® clamping point 22/50 5 mm receded.


Tensioning of the formwork according to a defined anchor grid. Production of sharp-edged, bleeding and discoloration-free anchor points by means of a support cone with a closed-cell 10 mm thick sealing foam ring on the formwork side and a rear sealing foam ring between the spreader and the support cone.  Support cone height = 50 mm. The formwork tie has to be re-tensioned during the concreting process.

Sealing of the tensioning point with a concrete cone 3-5 mm receded, matching the concrete in color and surface. The sealing is carried out after sampling and after approval by the client.

The air-side clamping points are bonded with a one-component, grey adhesive. Bonding of the room-side clamping points (no damp rooms) with a single-component, non-flammable adhesive. Pre-cut fixed lengths are to be used as expansion tubes. Cutting of the expansion pipes by the customer must be avoided.

Product of planning: MARO® clamping point 22/50 5 mm

Walzwerkstrasse 30
47877 Willich

Unit: Piece     Price: