69000498

Sleeve Cone 22/10/10 V2

1 cm sleeve cone not sealing ring to the formwork side and a small sealing ring to the formwork spreader. For a 15 mm tie rod.
System

Sleeve cone for production of formwork spacers with an interior diameter of 22mm, plastics or  zur Herstellung einer Schalungsspreize mit einem 22 mm Innendurchmesser aus Kunststoff oder fibre concrete. Suitable for a 15mm anchor rod

Technical Data

Support Cone: raw material HDPE (Polyethylen) ground material injected.

Sealing ring: closed cell foam material.

Properties

The sealing rings ensure that the clamping point is sealed against water loss from the fresh concrete.

The sealing ring on the formwork side prevents water components of the concrete from escaping through the tensioning hole in the formwork. The sealing ring on the spigot prevents water from escaping into the expansion pipe.

Color variants

The cone is red/white so that it can be checked in the course of the visual inspection whether all cones have been clamped in such a way that no sealing ring (red) is visible in relation to the cone (white).

Accessories

Cone Key

Weight per piece

ca. 8 gr.

Seal variants
Pieces per package

100 piece per package

500 pieces per box