BoQ
Sleeve Cone22/10/10 V2 resp. 26/10/10 V2
Production of clamping points.
Tensioning of the formwork according to a defined anchor grid. Production of sharp-edged, bleeding and discoloration-free clamping points by means of a support cone with a closed-cell 10 mm thick sealing foam ring on the formwork side and a rear sealing foam ring between the spreader and the support cone. Pre-cut fixed lengths are to be used as expansion pipes. Cutting of the expansion pipes by the customer must be avoided. Support cone height = 10 mm. The formwork anchor has to be retensioned during the concreting process. Depending on the tie rod DW15 or DW20, the suitable expansion pipe system has to be selected.
The subsequent sealing of the clamping points is done with suitable sealing cones.These are to be sampled in advance and are approved by the customer.
Product of planning: MARO®-Sleeve cone 22/10/10 V2 bzw. 26/10/10 V2 .
www.maro.info
MARO® GmbH
Walzwerkstrasse 30
47877 Willich
sales@maro.info
Unit: Piece Price:
Product data sheet:
MARO-Sleeve Cone 22/10/10V2
MARO-Vorsatzkonus 26/10/10V2
